Acopia Networks ARX 6000 Manuel d'utilisateur télécharger pdf (Page 9)

GUI Quick Start: Network

Setting Up Network Parameters

GUI Quick Start: Network Setup 1-7

Configuring Physical Ports

The next screen sets up the physical-Ethernet ports, called “interfaces” in the GUI and

CLI. Use this screen to enable one or more client/server ports, set their speed, and

assign them to a VLAN. If you select more than one port, the GUI aggregates the

ports into a channel.

For example, this ARX aggregates four ports into a channel over VLAN 25:

NOTE

The ARX supports static (non-LACP) link aggregation only. The L2 switch at the other

end of the channel must also support static aggregation. Further, it must include the

same ports and belong to the same VLAN. Cable this channel and configure it at the

other station before finishing this wizard.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

Pas de commentaire

Acopia Networks ARX 6000 Manuel d'utilisateur Page 9